产品导览
8051 Series Flash ADC / LED / LCD (Industrial Grade)
EM85F765N
联络我们
一般描述
特征
- System operating condition:16KHz~20 MHz @ 2.7~5.5V, -40°C~85°C
- High-speed pipelined 8051-compatible microcontroller
Memory
- 18KB of on-chip Flash memory
- Flash Memory 10000 writing cycle endurance
- Built-in In-Application-Programmable (IAP)
- (256+768)B of on-chip RAM
Clock Sources
- High frequency Internal Resistor & Capacitor oscillator (HIRC) with ± 2% total of deviation: 4MHz
Internal RC Frequency | Drift Rate | ||||
Process | Temperature(-40°C+85°C) | Voltage(2.7V~5.5V) | Total | ||
128 MHz | ±2% | ±3% | ±2% | ±7% | |
4MHz | ±0.25% | ±1.75% | ±2% |
- HXT 1M~4MHz
- External clock input
- PLL x48 only for Timer
- PLL x2~5 for CPU
- LXT 32.768KHz
- Low frequency (128K/32K/16KHz) Internal Resistor & Capacitor oscillator (LIRC)
- Operation Frequency: 16KHz~20MHz
Analog Peripherals
- 12-bit 100ksps single-ended ADC with (21+2) analog input channel
- One Operational Amplifier/Comparator with 2mV input offset voltage and 200ns response time
- Internal voltage reference for ADC: 4.096V/3.072V/2.560V/2.048V (1LSB: 1mV/0.75mV/0.625mV/0.5mV)
- Internal voltage reference for CMP: 2.048V/1.280V/0.512V/0.256V
- On-chip regulator: 1.5V ± 3% only for kernel use
- Power-on Reset (POR): 2.3/2.4V ±0.2V @ -40°C~85°C
- On-chip Low-voltage detect (HLVD): 2.5V, 2.6V,2.8V,2.9V, 3.1V, 3.3V,3.5V, 3.7V, 3.9V, 4.1V, 4.3V, 4.5V, 4.7V ±0.15V @ -40°C~85°C
- Brown Out Reset (BOR): 2.5V, 2.6V,2.8V,2.9V, 3.1V, 3.3V,3.5V, 3.7V, 3.9V, 4.1V, 4.3V, 4.5V, 4.7V ±0.15V @ -40°C~85°C
Digital Peripherals
- 1-set I2C (16 Bytes Buffer)
- 1-set UART: 8051’s own UART and the other one is Elan’s UART
- 1-set UART (16 Bytes Buffer)
- 1-set SPI (16 Bytes Buffer)
- 26 I/O pins, each supports pull-high, pull-low, normal drive/sink, and high drive/sink control functions
- Two standard 8051 16-bit timer/counters (TC0, TC1) with four operation modes (Mode 0~3)
- Two general-purpose 16-bit timer/counters (TC3, TC4) with six modes: Timer/Counter/Capture/Window/Buzzer/PWM/PDO (programmable divider output) modes. Its clock source comes from PLL 48 MHz.
- Three 16-bit Dual PWMs with either normal or trigger mode (need to be used together with CMP1,CMP2), their clock sources come from PLL 48 MHz.
- LED Driver
Packages
- 28-pin SOP: 300mil EM85F765NSO28
- 24-pin SOP: 300mil EM85F765NSO24
- 20-pin SOP: 300mil EM85F765NSO20
- 32-pin QFN: 4*4*0.6mm EM85F765NQN32
On-chip Debug2
- On-chip Debug system (OCD)
- Provide 6 ROM breakpoints, 1 IDATA/XDATA/SFR register breakpoint.
- Provide emulation instructions (such as free run, step into, system halt, wake-up, reset, etc.), inspection memory and registers information